Item #: 19
Our Price:
Add to Wishlist Add to Cart


Classic Pair of Angled 24 Double Row louvers panels for your project car, rat rod, jeep, sand toy, or boat. Louvers are made on a high tonage press brake for much crisper stronger forms (see photo). This is much easier and less expensive than having your fender, hood, panel or firewall removed and taken to the bodyshop and louvered. Just trim this panel to fit your and weld epoxy or rivet in place. These are made from 20ga cold roll steel. The louvers are 4 1/32 wide and 3/8 tall. the spacing is 1 1/4". Each panel has 24 louvers. The panel has plenty of flange room so you can cut to fit. The outer dimensions are 20" x 10" for each panel. One Pair one left and one right.


Average Rating: (based on 1 review)

Showing 1 Review:

by Doug
on 10/26/2011
off raad explorer
I have looked for and researched hood louvers for sometime, but I couldn't find anything I liked that was reasonably priced. That was until I found this particular pair. The price was right and the quality was top notch. They did need a little prep work to get them ready to install on my truck, but that was just fine with me. I just smoothed out the edges, drilled mounting holes where I needed them and after a good bath in solvent they were painted and mounted on my truck. Best thing is they work great. There is definite air movement out of them which has lowered the temperature of the engine compartment. Something I really needed since this ol truck is more of a rock crawler than anything else. Great product and good price. Thanks
Rate this item

Email A Friend

Send this product to a friend...

Subscribe to the RodLouvers newsletter

If you have any questions about any of our products please feel free to give Dave a call or email


Copyright © Auctiva Commerce